Page 1 of 1

[UC 1.4.0.3] command line broken or syntax changed?

Posted: Sat Mar 10, 2018 7:45 am
by SpiroC
Hi, on Win 10 64 bit, these commands don't work anymore. I use the command line call for integration into my explorers (both XYPlorer and MuliCommander).

ultracopier.exe cp "D:\_Test\4\test1.txt" "D:\_Test\5"
ultracopier.exe cp "D:\_Test\4\test1.txt" "D:\_Test\5\"

Sometimes I get nothing at all, sometimes I get a new folder in the destination with the name of the parent folder, sometime UC stays open with an error message about not being able to find:
D:/_Test/5/"5/"
just like that with slashes reversed and the last folder repeated with a quote at the end. I tried both test commands with v1.4.0.3 free, v1.4.0.4 free/portable/pro and pro i-core. Not sure if this is a bug or if the command line syntax has changed. I checked the wiki for changes and the forum for the changelog but haven't spotted any info yet. I have rolled back to v1.2.3.6 and it's working again.

Re: [UC 1.4.0.3] command line broken or syntax changed?

Posted: Sat Mar 10, 2018 9:04 pm
by alpha_one_x86
Should not, I need investigate on this